Specifications

Crestron Isys i/O
™
TPMC-15/17-L Series Touchpanel Media Centers
“Wireless Network Connection” Window
Click Refresh network list to scan for available access points.
The TPMC-15/17-L is already configured for DHCP. To establish static processing
or to switch between DHCP and static IP, use the General tab of the “Wireless
Network Connections” window (refer to illustration on page 44), select Internet
Protocol (TCP/IP) and click Properties.
Click Set up a wireless network for a home or small office to start the Wireless
Network Setup Wizard.
The Wireless Network Setup Wizard will create a network with the Network
Authentication value set to Open. If your Wireless Access Point is configured with a
value other than Open, you must set this value manually, using the Wireless
Networks tab of the “Wireless Network Connection Properties” window (refer to
illustration on page 44).
To manually configure your Wireless Access Point, perform the following
procedure:
1. In the Preferred Networks section of the window, select your network and
click Properties to open the “Properties” window for your network.
Operations Guide – DOC. 6354B Touchpanel Media Centers: Crestron Isys i/O™ TPMC-15/17-L Series • 45