Specifications

Touchpanel Media Centers Crestron Isys i/O
™
TPMC-15/17-L Series
“Touch Screen/Console Settings” Window
When the serial port is enabled, parameters for serial communications can be set in
the Console Settings section of the window.
To view the mouse cursor on the touchpanel, select On in the Mouse Cursor section
of the window. The mouse cursor will only be displayed if a mouse is connected to
the touchpanel.
When Calibrate Touch Screen… is pressed, the calibration screen will be
displayed. Touch the screen to begin the calibration process. If the screen is not
pressed within sixty seconds, the calibration sequence will stop and the screen will
return to the “Touch Screen/Console Settings” window.
If the screen is touched before the sixty second timeout, the screen instructs you to
touch the center of each target as it appears. There will be a series of crosshairs on
the panel, starting near the upper left corner. Touch the center of the first crosshair to
initiate calibration. As each new crosshair is touched, the next will appear. After the
upper left, crosshairs will appear in the upper center, upper right, middle left, screen
center, middle right, lower left, lower center and finally lower right. Touch the center
of the crosshair in the lower right of the screen to conclude calibration and return to
the “Touch Screen/Console Settings” window.
NOTE: When touching the screen during calibration, be as accurate as possible.
Use the tip of a capped pen or the eraser end of a pencil. To cancel calibration and
return to the “Touch Screen/Console Settings” window without saving calibration
data, create a calibration error by touching the screen in the same spot for each
calibration point.
NOTE: The touchpanel’s calibration routine can also be accessed through Crestron
Toolbox if the touchpanel is connected to a control system via Cresnet and/or
TCP/IP or to a PC via RS-232 by selecting the device from the Network Device Tree
and right-clicking the device to select Functions | Setup Mode…. Select Enter
Calibration Mode to begin calibration.
Press OK to accept the changes and return to the SETUP MENU. A window will
appear to remind you that you must reboot for the changes to take effect.
When Touch Screen Test is pressed, the test screen will be displayed (refer to
illustration on the following page). This screen allows the user to test the touch
30 • Touchpanel Media Centers: Crestron Isys i/O™ TPMC-15/17-L Series Operations Guide – DOC. 6354B