Specifications
Touchpanel Media Centers Crestron Isys i/O
™
TPMC-15/17-L Series
Connectors, Controls & Indicators (Continued)
#
CONNECTORS
1
,
CONTROLS &
INDICATORS
DESCRIPTION
10
PWR IN
(2) 2-pin detachable terminal blocks,
paralleled;
Used to extend power cabling up to 60 feet
using 4 conductor, 14 AWG wire connected
to a TPMC-L-IMC power interface module
(included) at remote power supply location.
11
PWR OUT
(1) 4-pin DC power jack;
Connects to PWR jack using 9-inch 4-pin DC
power patch cable (included) when locating
power supply remotely; passes 12.5 VDC
power from PWR IN terminal blocks.
12
UNDER & OVER
VOLTAGE LEDs
Indicate under or over voltage condition
(refer to page 60 for details).
13 BUTTONS
8
(4) Backlit “softkey” buttons, programmable
(1) Backlit hard reset button, reboots the
touchpanel
1. An interface connector for the NET port is provided with the unit.
2. Only generic USB devices (i.e. simple keyboard, mouse and external storage) should be used. Any
complex USB devices (e.g. a storage device with a built-in fingerprint scanner) will not have the
proper support on the panel.
3. Only standard Windows
®
XP embedded drivers are included. You cannot load your own driver. The
maximum length for a USB cable run is 16.4 feet (5.0 meters).
4. Use only the TPMC-CH-IMC Interface Module when connecting this port. Use of other “IMC”
products could damage the panel.
5. This eight-pin RJ-45 port provides connectivity to the CNX-PVID or the TPMC-CH-IMC Interface
Module. This port provides component, composite or S-video balanced input to the touchpanel over
CAT5 wiring. Refer to the following table for connector pinouts.
PIN
WIRE COLORS
(568B)
WIRE COLORS
(568A)
Composite S-Video Component
1 WHITE/ORANGE WHITE/GREEN + Composite + Luminance + Y
2 ORANGE GREEN - Composite - Luminance - Y
3 WHITE/GREEN WHITE/ORANGE N/A + Chrominance + P
b
4 BLUE BLUE N/A N/A + P
r
5 WHITE/BLUE WHITE/BLUE N/A N/A - P
r
6 GREEN ORANGE N/A - Chrominance - P
b
7 WHITE/BROWN WHITE/BROWN N/A N/A N/A
8 BROWN BROWN N/A N/A N/A
6. This eight-pin RJ-45 port provides connectivity to the CNX-BIPAD or the TPMC-CH-IMC Interface
Module. This port uses CAT5 wiring and provides audio input to the touchpanel and output from the
touchpanel’s built-in microphone. Refer to the following table for connector pinouts.
PIN WIRE COLORS (568B)
WIRE COLORS
(568A)
Audio i/O
1 WHITE/ORANGE
WHITE/GREEN
+ Mic Left Out
2 ORANGE
GREEN
- Mic Left Out
3 WHITE/GREEN
WHITE/ORANGE
+ Mic Right Out
4 BLUE
BLUE
+ Audio Left In
5 WHITE/BLUE
WHITE/BLUE
- Audio Left In
6 GREEN
ORANGE
- Mic Right Out
7 WHITE/BROWN
WHITE/BROWN
+ Audio Right In
8 BROWN
BROWN
- Audio Right In
20 • Touchpanel Media Centers: Crestron Isys i/O™ TPMC-15/17-L Series Operations Guide – DOC. 6354B