Specifications

Sonnex™ Multiroom Audio Expansion Switcher, 8 Zone Crestron SWE-8

Connectors, Controls & Indicators (Continued)

CONNECTORS

CONTROLS &

INDICATORS

DESCRIPTION

24 VDC 2.0A

(1) 2.1 mm barrel DC power jack;

24 Volt DC power input

(power pack included)

GROUND

(1) 6-32 screw, chassis ground lug

1. Interface connectors for SPEAKER OUTPUTS ports are provided with the unit.

2. To determine which is pin 1 on the cable, hold the cable so the end of the eight pin modular plug is

facing away from you, with the clip down and copper side up. Pin 1 is on the far left.

3. For connection of the Sonnex Link between the SWE-8 and the SWAMP-24X8 or S-EXT1-S, use

Crestron DM-CBL-8G or high-quality CAT5e shielded twisted-pair cable. The maximum cable length

is 200 ft (61 meters) per run.

For longer distances, use the S-EXT1-S.

4. All analog outputs are paralleled per zone.

5. This eight-pin RJ-45 port uses CAT5 wiring to provide connectivity to the ABAR-1 CAT5 Balanced

Audio Receiver and other Crestron Home products such as the C2N-IADS30X24, CNX-BIPAD8,

CNXRMCLV, C2N-DAP8, and certain Crestron touch screens. Refer to the following table for

connector pinouts.

PIN WIRE COLORS (568B) AUDIO I/O

1 WHITE/ORANGE + Left Out

2 ORANGE - Left Out

3 WHITE/GREEN + Right Out

4 BLUE N/A

5 WHITE/BLUE N/A

6 GREEN - Right Out

7 WHITE/BROWN N/A

8 BROWN N/A

8  Sonnex™ Multiroom Audio Expansion Switcher, 8 Zone: SWE-8 Operations Guide – DOC. 7202A