Specifications

Sonnex Multiroom Audio System Crestron SWAMP(I)-24X8
40
•
Sonnex Multiroom Audio System: SWAMP(I)-24X8 Operations Guide – DOC. 7049D
2. Press
q
or ▲ to display IP ID and press ENTER. The “IP ID” screen is
displayed.
“IP ID” Screen
IP ID
03
▲
q
3. Press
q
or ▲ to display the desired setting and press ENTER. The display
returns to the previous screen.
Set the Control System IP
Address
If the SWAMP-24X8 is to communicate with a control system over TCP/IP, the
control system’s IP address must be set. To set the control system’s IP address using
the front panel, perform the following procedure:
1. Enter the “Control Setup” menu as described on page 39.
2. Press
q
or ▲ to display Ctrl Sys IP Addr and press ENTER. The “Ctrl Sys
IP Addr” screen is displayed.
“Ctrl Sys IP Addr” Screen
Ctrl Sys IP Addr
[172]
030. 016
. 186
3. Press
q
or ▲ to set the first octet of the control system IP address.
4. Press the button under the next octet (or press ENTER to move to the next
octet) to select it for editing.
5. Repeat steps 3 and 4 for each octet.
6. To save the control system IP address and return to the “Control Setup”
menu, move the cursor to the right-most octet and press ENTER. To cancel
the operation and return to the previous screen, press MENU.
About
Select this option to view information about the operating firmware in the
SWAMP-24X8. To view information about the SWAMP-24X8, perform the
following procedure:
1. Enter the “Installer Mode” menu as described in “Enter the “Installer
Mode” Menu” on page 26.
2. Press
q
or ▲ to display About and press ENTER.
3. Press
q
or ▲ to display information about the SWAMP-24X8.
4. Press ENTER to return to the “Installer Mode” menu.