Specifications

Sonnex Multiroom Audio System Crestron SWAMP(I)-24X8
36
•
Sonnex Multiroom Audio System: SWAMP(I)-24X8 Operations Guide – DOC. 7049D
Amplifier Status
Select this option to view the settings and operating status of each of the
SWAMP-24X8 amplifiers as well as the amplifiers of connected expanders. To view
information about the amplifier, perform the following procedure:
1. Enter the “Installer Mode” menu as described in “Enter the “Installer
Mode” Menu” on page 26.
2. Press
q
or ▲ to display Amplifier Status and press ENTER. The
“Amplifier Status” menu is displayed.
A list of amplifier faults or view information about a specific zone can be viewed
from the “Amplifier Status” menu.
View Amplifier Faults
To view a list of amplifier faults in all of the zones, perform the following procedure:
1. Press
q
or ▲ to display Faults and press ENTER.
2. Press
q
or ▲ to scroll through the list of amplifier faults.
3. Press MENU to return to the “Amplifier Status” menu.
4. Press MENU to return to the “Installer Mode” menu.
View Zones
To view information for a specific zone, perform the following procedure:
1. Press
q
or ▲ to display the desired zone and press ENTER.
2. Press
q
or ▲ to scroll through the available information.
3. Press MENU to return to the “Amplifier Status” menu.
4. Press MENU to return to the “Installer Mode” menu.
Network Setup
Select this option to configure and view the SWAMP-24X8 network settings.
Enter/Exit the “Network
Setup” Menu
To enter the “Network Setup” menu, perform the following procedure:
1. Enter the “Installer Mode” menu as described in “
Enter the “Installer Mode”
Menu” on page 26.
2. Press
q
or ▲ to display Network Setup and press ENTER.
3. To exit the “Network Setup” menu and return to the “Installer Mode” menu,
press MENU.
Set the IP Address
The SWAMP-24X8 can use TCP/IP for communication between a control system
and a SWAMP-24X8. The IP address can be manually set or obtained from a DHCP
server. For information on enabling DHCP to obtain an IP address, refer to
“Enable/Disable DHCP” on page 38
. To view or manually set an IP address, perform
the following procedure:
1. Enter the “Network Setup” menu as described on page 36.
2. Press
q
or ▲ to display IP Address and press ENTER. The “IP Address”
screen is displayed.
“IP Address” Screen
IP Address
[172] 030. 017. 025