Specifications

Sonnex Multiroom Audio System Crestron SWAMP(I)-24X8
34
•
Sonnex Multiroom Audio System: SWAMP(I)-24X8 Operations Guide – DOC. 7049D
Set Speaker Impedance
To specify the impedance of speakers connected to a zone output, perform the
following procedure:
1. Enter the “Zone Setup” menu as described in “Enter/Exit the “Zone Setup”
Menu” on page 28.
2. Press
q
or ▲ to display Impedance and press ENTER. A list of zones is
displayed.
3. Press
q
or ▲ to display the zone to be configured and press ENTER. The
Impedance screen is displayed.
Impedance Screen
Zone 1
Impedance
8
Ohm
q
4. Press
q
or ▲ to display the speaker’s impedance rating and press ENTER.
5. Repeat for every zone to be configured.
6. Press MENU to return to the “Zone Setup” menu.
Set Speaker Protection
To enable/disable speaker protection for a zone output, perform the following
procedure:
NOTE: As speaker ratings vary greatly across manufacturers, there is no guarantee
that Sonnex Speaker Protect protects against speaker damage in all situations.
1. Enter the “Zone Setup” menu as described in “Enter/Exit the “Zone Setup”
Menu” on page 28.
2. Press
q
or ▲ to display Speaker Protect and press ENTER. A list of zones
is displayed.
3. Press
q
or ▲ to display the zone to be configured and press ENTER. The
Protect screen is displayed.
Protect Screen
Zone 1
Protect On
q
4. Press
q
or ▲ to display the desired speaker protection setting and press
ENTER.
5. Repeat for every zone to be configured.
6. Press MENU to return to the “Zone Setup” menu.
Set Crestron Dynamic Range
Control (DRC)
To enable/disable DRC for a zone output, perform the following procedure:
1. Enter the “Zone Setup” menu as described in “
Enter/Exit the “Zone Setup”
Menu” on page 28.
2. Press
q
or ▲ to display Crestron DRC and press ENTER. A list of zones
is displayed.
3. Press
q
or ▲ to display the zone to be configured and press ENTER. The
Crestron DRC screen is displayed.