Specifications

Crestron SWAMP(I)-24X8 Sonnex Multiroom Audio System

Operations Guide – DOC. 7049D Sonnex Multiroom Audio System: SWAMP(I)-24X8

•

2. Press ENTER to select Source Setup.

3. Press ENTER to select Compensation.

4. Press

or ▲ until the input source to be adjusted is displayed.

5. Press ENTER to select the input source and display the Gain screen.

Gain Screen

Source 1

Gain 0.0 dB

▲

6. Press

or ▲ to display the amount of gain to be applied and press

ENTER. The display returns to the list of input sources.

7. Repeat steps 4 through 6 for each input source.

8. Press MENU twice to return to the “Installer Mode” menu.

Zone Setup

Select this option to adjust the following parameters for each zone:

• EQ (Equalization) chooses an EQ setting from six preset equalization

settings.

• Bass adjusts the bass level to the desired preference.

• Treble adjusts the treble level to the desired preference.

• Loudness applies loudness compensation to any signal routed to a zone.

• Balance adjusts the balance to the desired preference.

• Mono sets the zone for mono or stereo sound.

• Minimum Volume specifies the lowest volume to which the zone can be set.

• Maximum Volume specifies the highest volume to which the zone can be

set.

• Startup Volume specifies the volume level that is used when a zone is

turned on.

• Bussing assigns the selected zone to a group of zones (bus). Zones in a bus

track each others’ volume and source (i.e. when the source or volume for

one zone in the bus is adjusted, the other zones in that bus follow).

• Bus Volume Offset specifies a volume offset between -12 and +12 dB that is

applied on top of the volume setting for the selected zone when it is a

member of a bus. Since zone volumes track in a bus this ensures the

selected zone is always at the specified level above/below the other zones in

the bus.

• Bussing Lists displays the zones that are currently members of a bus.

• Bridging selects output zones to be bridged.

• Wattage specifies the wattage rating for a speaker that is connected to a

selected zone. This value is used by the Speaker Protect algorithm. When

enabled, the Speaker Protect function prevents the delivered power from

exceeding the speaker’s power rating.