Specifications

Sonnex Multiroom Audio System Crestron SWAMP(I)-24X8

•

Sonnex Multiroom Audio System: SWAMP(I)-24X8 Operations Guide – DOC. 7049D

Configuration

After making all hardware connections, the SWAMP-24X8 must be configured for

operation. The SWAMP-24X8 can be configured from the SWAMP-24X8’s front

panel using the “Installer Mode” menu or from a PC using the Sonnex Tools

application in Crestron Toolbox. This document contains instructions for using the

"Installer Mode” menu. For information on using Sonnex Tools to configure the

SWAMP-24X8, refer to the Sonnex Tools help file.

Power

Turn on the SWAMP-24X8 by moving the POWER switch to . To turn off the

SWAMP-24X8, move the POWER switch to .

Enter the “Installer Mode”

To enter the “Installer Mode” menu, press and hold q and ▲ for approximately 5

seconds. The “Installer Mode” menu is displayed.

“Installer Mode” Menu

Installer Mode

Source Setup

The “Installer Mode” menu is separated into seven menus:

• Source Setup adjusts the compensation level for each of the input sources.

• Zone Setup configures each output zone’s settings for audio, Sonnex links

(busses), bridging (with other outputs), and power output.

• Expander Status provides the status of each connected SWAMPE Sonnex

Multiroom Audio Expander.

• Amplifier Status shows the settings and operating status of each of the

SWAMP-24X8 amplifiers as well as the amplifiers of connected SWAMPE

Sonnex Multiroom Audio Expanders.

• Network Setup configures and views the Ethernet settings of the

SWAMP-24X8.

• Control Setup configures the SWAMP-24X8 for use with a Crestron control

system and lock/unlock the front panel controls.

• About displays information about the firmware.

NOTE: Changes made to any setting are only saved upon exiting the “Installer

Mode” menu. For instructions on exiting the “Installer Mode” menu, refer to “Exit

the “Installer Mode” Menu

” below.

Exit the “Installer Mode” Menu

To exit the “Installer Mode” menu, press MENU until the “Installer Mode” menu is

displayed (refer to illustration above), release and press MENU again.

Source Setup

Select this option to adjust the compensation level of each input source. To set the

compensation level, perform the following procedure:

1. Enter the “Installer Mode” menu as described in “Enter the “Installer

Mode” Menu” above.