Specifications

Sonnex Multiroom Audio System Crestron SWAMP(I)-24X8
20
•
Sonnex Multiroom Audio System: SWAMP(I)-24X8 Operations Guide – DOC. 7049D
Hardware Hookup
Connect the Device
Make the necessary connections as called out in the illustration that follows this
paragraph. Refer to “Network Wiring” and “Sonnex Link Wiring” on page 17
for
additional information. Apply power after all connections have been made.
Hardware Connections for the SWAMP-24X8
P
OWE
R:
From Line Voltage
ANALOG SOURCES:
From Analog Audio Sources
DIG
I
TA
L OUT:
To Sonnex
Expanders
SP
DI
F S
OURC
E
S:
From Digital
Audio Sources
SPDI
F
OUT:
To Digital Audio
Receiver
SPEAKER
OUTP
UTS:
To Speakers or SAT-70V/100V Sonnex Output Transformer
L
AN:
10BASE-T/100BASE-TX
Ethernet to LAN
N
ET:
To Cresnet Devices
Gr
ound
CAUTION: Keep the device unplugged until all of the input, network, and speaker
wiring is complete.
CAUTION: Check the speaker wires for shorts and frayed wiring around the
SPEAKER OUTPUTS connectors.
NOTE: Ensure the unit is properly grounded by connecting the chassis ground lug
to an earth ground (building steel).
NOTE: To prevent overheating, do not operate this product in an area that exceeds
the environmental temperature range listed in the table of specifications.
Four balanced/unbalanced audio inputs are provided, utilizing five-pin terminal
block connectors. For connection details, refer to the following table and diagrams.
Audio Connections
SIGNAL
NAME
BALANCED AUDIO
INPUT
UNBALANCED AUDIO
INPUT
L + Source L + Source L +
L - Source L - Source L - jumper to GND
G Shield/Ground Ground
R + Source R + Source R +
R - Source R - Source - jumper to GND