Specifications

Crestron SWAMP(I)-24X8 Sonnex Multiroom Audio System

Operations Guide – DOC. 7049D Sonnex Multiroom Audio System: SWAMP(I)-24X8

•

• Circuit Overloading - Consideration should be given to the connection of

the equipment to the supply circuit and the effect that overloading of the

circuits might have on overcurrent protection and supply wiring.

Appropriate consideration of equipment nameplate ratings should be used

when addressing this concern.

• Reliable Earthing - Reliable earthing of rack-mounted equipment should be

maintained. Particular attention should be given to supply connections other

than direct connections to the branch circuit (e.g., use of power strips)

NOTE: Feet are preinstalled for tabletop mounting or stacking. If the unit is to be

rack mounted, the feet are not required and can be removed to provide more space in

the rack.

To install the ears, use the following procedure.

CAUTION: To prevent equipment damage, use only the rack ears Crestron

provides for this device.

1. There are screws that secure each side of the SWAMPE-8 top cover. Using

a #1 or #2 Phillips screwdriver, remove the three screws closest to the front

panel from one side of the unit. Refer to the diagram following step 3 for a

detailed view.

2. Position a rack ear so that its mounting holes align with the holes vacated

by the screws in step 1.

3. Secure the ear to the unit with three screws from step 1, as shown in the

following diagram.

Ear Attachment for Rack Mounting

4. Repeat procedure (steps 1 through 3) to attach the remaining ear to the

opposite side.

Stacking

Four “feet” are preinstalled with the SWAMP-24X8 so that if the unit is not rack

mounted, the feet can provide stability when the unit is placed on a flat surface or

stacked.

NOTE: No more than two SWAMP-24X8 units should be stacked.