Specifications

Sonnex™ Multiroom Audio System Crestron SWAMP(I)-24X8
Bus Display
4.
Press the T or ▲ buttons to display the other zones contained in the bus.
5.
Press ENTER to return to the list of busses.
6.
Repeat for every bus to be viewed.
7.
Press MENU to return to the “Zone Setup” menu.
Bridge Outputs
To bridge outputs together:
1.
Enter the “Zone Setup” menu as described in “Enter/Exit the “Zone Setup”
Menu” on page 27.
2.
Press the T or ▲ buttons to display Bridging and press ENTER. A list of
zones is displayed.
3.
Press the T or ▲ buttons to display the zone to be configured and press
ENTER. The bridging setting is displayed.
NOTE: Since only odd-numbered zones can be bridged with their
respective, adjacent, even-numbered zones, only odd-numbered zones are
listed.
Bridging Setting
4.
Press the T or ▲ buttons to display the desired bridging setting and press
ENTER.
NOTE: Bridged outputs are indicated with LEDs near the speaker
terminals on the rear of the SWAMP-24X8 and SWAMPE Multiroom
Audio Expander.
5. Repeat for every zone to be bridged/unbridged.
6.
Press MENU to return to the “Zone Setup” menu.
Set Speaker Wattage Rating
To specify the wattage of speakers connected to a zone output:
1.
Enter the “Zone Setup” menu as described in “Enter/Exit the “Zone Setup”
Menu” on page 27.
2.
Press the T or ▲ buttons to display Wattage and press ENTER. A list of
zones is displayed.
3.
Press the T or ▲ buttons to display the zone to be configured and press
ENTER. The wattage setting is displayed.
32 • Sonnex™ Multiroom Audio System: SWAMP(I)-24X8 Operations & Installation Guide – DOC. 7049B