Specifications

Crestron SWAMP(I)-24X8 Sonnex™ Multiroom Audio System
• Impedance: Specifies the impedance of a speaker connected to a selected
zone.
•
Speaker Protect: Enables or disables the Speaker Protect function.
NOTE: As speaker ratings vary greatly across manufacturers, there is no
guarantee that Sonnex Speaker Protect protects against speaker damage in
all situations.
• Crestron DRC: Enables or disables the Crestron Dynamic Range Control
function.
• Global EQ: Sets the same EQ preset for all zones in the system. Setting this
option overrides any EQ selection that was previously set for an individual
zone.
Enter/Exit the “Zone Setup”
Menu
To enter the “Zone Setup” menu:
1.
Enter the “Installer Mode” menu as described in “Enter the “Installer
Mode” Menu” on page 25.
2.
Press the T or ▲ buttons to display Zone Setup and press ENTER.
3.
To exit the “Zone Setup” menu and return to the “Installer Mode” menu,
press MENU.
Set EQ (Equalization)
To adjust a zone’s EQ setting:
1.
Enter the “Zone Setup” menu as described in “Enter/Exit the “Zone Setup”
Menu” above.
2.
Press ENTER to select EQ.
3.
Press the T or ▲ buttons to display the zone to be controlled and press
ENTER. The EQ setting is displayed.
EQ Setting
4. Press the T or ▲ buttons to display the setting to be applied and press
ENTER.
5.
Repeat for every zone to be adjusted.
6.
Press MENU to return to the “Zone Setup” menu.
Set Bass
To adjust a zone’s bass setting:
1.
Enter the “Zone Setup” menu as described in “Enter/Exit the “Zone Setup”
Menu” above.
2.
Press the T or ▲ buttons to display Bass and press ENTER. A list of
zones is displayed.
3.
Press the T or ▲ buttons to display the zone to be controlled and press
ENTER. The bass setting is displayed.
Operations Guide – DOC. 7049B Sonnex™ Multiroom Audio System: SWAMP(I)-24X8 • 27