Specifications

Sonnex™ Multiroom Audio System Crestron SWAMP(I)-24X8
SWAMP-24X8 to SWAMPE Connection (SWAMPE-8 shown)
NOTE: The maximum cable length between a SWAMP-24X8 and a peripheral is
200 feet (61 meters).
Fuse Replacement
If the SWAMP-24X8 does not power up when it is plugged into an AC outlet, the
fuse may need to be replaced. The fuse holder is located on the rear panel, above the
IEC socket assembly. To replace the fuse:
1.
Use a flat head screwdriver to push in the fuse holder.
2.
While pushing in the fuse holder, turn screwdriver counterclockwise until
the fuse holder pops out.
3.
Remove the fuse from the fuse holder and insert a new fuse.
CAUTION: Only use the specified type of fuse when replacing a blown
fuse. Failure to do so may cause damage to the device.
SWAMP-24X8 MODEL REQUIRED FUSE TYPE
SWAMP-24X8
(US & Canada)
T15AH (1/4” x 1-1/4”, 250V, 15A,
time-lag, high-rupture rated)
SWAMPI-24X8
(International/220-240VAC)
T8AH (5 mm x 20 mm, 250V, 8A,
time-lag, high-rupture rated)
4. Insert the fuse holder into the device.
5.
Push in the fuse holder with a flat head screwdriver. While pushing in the
fuse holder, turn the screwdriver clockwise until the fuse holder sinks in.
6.
Push in the fuse holder a little further and turn the screwdriver clockwise
until the fuse holder locks in place.
7.
Connect power to the device.
Label the Buttons
Use Crestron Engraver software to print custom labels for the SWAMP-24X8’s front
panel buttons and LEDs. Crestron recommends printing on 100-pound paper. Paper
weighing less than 100 pounds tends to crumple while sliding in, while paper
weighing more than 100 pounds may not fit.
24 • Sonnex™ Multiroom Audio System: SWAMP(I)-24X8 Operations & Installation Guide – DOC. 7049B