Specifications

Sonnex™ Multiroom Audio System Crestron SWAMP(I)-24X8
Typical Balanced/Unbalanced Inputs
+ - G + -
+
+
Balanced
Input
Shield
Source L
Source R
L R
Jumpers
+ - G + -
+
+
Unbalanced
Input
Source L
Source R
Shield
Shield
L R
CH Device Connections
Devices with a RJ-45 CH output such as the CEN-IDOCV can be connected to the
balanced inputs on the SWAMP-24X8 as shown in the following table.
CH Output to SWAMP-24X8 Balanced Input
PIN WIRE COLORS (568B) AUDIO I/O
BALANCED INPUT
CONNECTION
1 WHITE/ORANGE + Audio Left Out L +
2 ORANGE - Audio Left Out L -
3 WHITE/GREEN + Audio Right Out R +
4 BLUE N/A
5 WHITE/BLUE N/A
6 GREEN - Audio Right Out R -
7 WHITE/BROWN N/A
8 BROWN N/A
Speaker Connections
Make speaker connections to the SWAMP-24X8 as shown in the following diagram.
Speaker Connections
+
-
-
+
NOTE: If the SAT-70V/100V Sonnex Output Transformer is connected to a
speaker terminal, use the SAT-70V/100V profile built into the Sonnex Tools
application to configure a high-pass filter on the zone that is connected to the
SAT-70V/100V. For details, refer to the Sonnex Tools help file.
20 • Sonnex™ Multiroom Audio System: SWAMP(I)-24X8 Operations & Installation Guide – DOC. 7049B