Specifications

Crestron SWAMP(I)-24X8 Sonnex™ Multiroom Audio System
Connectors, Controls & Indicators (Continued)
#
CONNECTORS
1
,
CONTROLS &
INDICATORS
DESCRIPTION
20
GROUND
(1) 6-32 screw, chassis ground lug
21
SPEAKER OUTPUTS
(1-8)
(16) 2-pin 7.62mm 15A detachable terminal
blocks;
Power amplifier outputs;
Wire Size: Terminals accept up to 14 AWG;
The following outputs can be bridged
together: 1 and 2 (L+R), 3 and 4 (L+R), 5 and
6 (L+R), 7 and 8 (L+R);
Red LED indicates bridged operation
NOTE: Outputs can only be bridged into an 8
ohm load.
1. Interface connectors for NET, ANALOG SOURCES (BALANCED), and SPEAKER OUTPUTS
ports are provided with the unit.
2. Refer to “Fuse Replacement” on page 24 for additional details.
3. Port on SWAMPI-24X8 is labeled 220-240V~50/60Hz MAX 6A.
4. Supports any combination of up to eight SWAMPE Multiroom Audio Expanders or S-EXT1-S
Sonnex Link Over Fiber Extenders (connected to a SWAMPE Multiroom Audio Expander). For
connection of the Sonnex Link between the SWAMP-24X8 and each peripheral, use Crestron
DM-CBL-8G or high-quality CAT5e shielded twisted-pair cable. The maximum cable length is 200 ft
(61 m) per run.
5. If using Cresnet for communications between the SWAMP-24x8 and a control system, only one
SWAMPE Multiroom Audio Expander or one S-EXT1-S Sonnex Link Over Fiber Extender
(connected to a SWAMPE Multiroom Audio Expander) can be connected.
Operations Guide – DOC. 7049B Sonnex™ Multiroom Audio System: SWAMP(I)-24X8 • 15