Specifications

Crestron e-control Vote SW-VOTE

79 •• Appendices Installation & Reference Guide — DOC. 5822

Abort Voting Console

Description

Abort voting sequence

Direction

Voting Computer to control system

Type

Digital

Value

Assert: Results now being recorded on Voting Computer

([Print &] Save Results button feedback ON)

De-assert: Results have been recorded

([Print &] Save Results button feedback OFF)

Expected Reply

AgendaEcho, NewVote,

Comments

This signal is accepted by the Voting Computer while the floor is opened and after

the floor is closed but before the vote is recorded. When accepted, voting computer

responds as follows (in the order given):

§ All “state” signals are de-asserted

§ NewVote pulse

§ All digital “tally” signals are de-asserted and analog “tally” signals are reset to 0

§ All Change

signals are reset to 1 (present) if aborting attendance taking or either 0

(absent) or 1 (present) if aborting a vote

§ AgendaEcho with the value “[Vote aborted]”

Used in conjunction with the other “state” signals, StateStart, StateEnd, and

StateDisplay; and the pulsed signals, NewVote and AgendaTrigger. These

signals provide feedback to the control system about the voting sequence. They

can be used to highlight the sequence control buttons, or to enable/disable

touchpanel choices. (See “State Coordination,” page 61, for a “score sheet”

illustrating the sequence.)

This signal is only valid during a vote (when StateStart, StateEnd, or

StateDisplay is high). If issued at the wrong time, the following descriptive error

message is sent through the ErrString signal:

To start, press TAKE ATTENDANCE or START VOTE