User manual

DCS 6000 Digital Conference System User Manual
35
#
Menu
Settings
Description
16.
Audio Output –
The ‘Source’ can be selected
for each of the four outputs.
The choices using the
dropdown menu are:
Group, Floor, Floor 1, Floor 2
or any of the interpreter
channels.
When ‘Group’ is selected for
‘Out A’, the ‘Group A’ is the
source and similar for the
three other outputs.
The ‘Floor or Interpreter
Channel’ selection is used
either for recording of the
interpreted languages or for
connection to a wireless
language distribution system.
The ‘Floor 1 or Floor 2’
selection is used when
connection to external PA
system.
If ‘Floor, Floor 1, Floor 2 or
any of the interpreter
channels’ is selected for an
output (Out A, B, C & D) the
corresponding group is
disabled in the ‘Group Setup’.
The ‘Audio Out Volume’ can be
set for each of the four audio
outputs (A, B, C & D).
17.
Group Setup –
The Conference units can be
assigned individually to four
groups.
‘Group A’ is always used as
the source to the built-in
loudspeakers. A unit can be
selected in ‘Group A’ and/or in
one of the other three groups.
If a unit is not selected in
‘Group A’ the audio from this
unit cannot be available in the
built-in loudspeakers.
The ‘Group’ facility is used if
separate microphones are
required to be recorded or if
external equalization or
volume control is required.
Note: A microphone can only
be present in ‘Group A’ and in
one other group.