User manual

DCS 6000 Digital Conference System User Manual
34
#
Menu
Settings
Description
15.
Input Control –
The Gain of ‘Audio In 1 & 2’
can be set to ‘0 dB’ or ‘10 dB’.
When set to ‘10 dB’ the input
signal is amplified 10 db.
The ‘Audio In 1 & 2 Volume’ is
used to set the volume of the
input signal.
‘Audio In 1 & 2’ can be routed
to the ‘Loudspeakers’, ‘Floor’
(headphones) in the
Conference units as well as to
‘Out. A’ output using the
selection buttons.
‘Audio In 1 or 2’ will only be
present at ‘Out. A’ if ‘Group’ is
selected as the source to the
‘Out A’ output, where it will be
mixed with the ‘Group A’
signal. See next menu point.
The audio from the conference
microphones, which are
selected in ‘Group A’ can be
routed to the Loudspeaker
and/or Floor.