User manual

DCS 6000 Digital Conference System User Manual
18
The CU 6105 is connected to the Conference Units
using EC 6001-xx Cat5e cables.
This configuration is used when ‘Floor’ audio or
audio from one or more microphones is required to
be recorded.
Use the ‘Group’ selection for the four outputs
and select the seats for each group. Refer to
section ‘Please refer to section ‘Web Browser
Setup and Control’ item #8 for more
information.
Figure 0-E Connecting the DCS 6000 Digital Conference System to an audio recorder.
Connecting an audio mixer
The CU 6105 is connected to the Conference Units
using EC 6001-xx Cat5e cables.
This configuration is used when the volume from
one or more microphones is required to be
controlled separately or equalization is needed.
One or more Outputs are connected to the
external mixer, where the control or equalization is
done.
The audio from the audio mixer is then send back
to the CU using the ‘Audio In 1 or 2’ input.
Use the ‘Group’ selection for the four outputs
and make seat selection for each group. Refer
to section ‘‘Web Browser Setup and Control’’
item #8.
Important: If ‘Out A’ is also send to the mixer the
following settings must to be done:
‘CU 6105 Setup * Audio * Loudspeaker Control *
Microphone -> Loudspeaker’ shall be set to ‘Off’.
‘In 1 or 2 -> Out. A’ shall be un-selected in the
selection ‘CU 6105 Setup * Audio * Input/Output
Control * Audio In 1 or 2’.
Figure 0-F Connecting the DCS 6000 Digital Conference System to an audio mixer.