Specifications

Crestron e-control Mail SW-MAIL
33 •• Server Configuration In Depth Installation & Reference Guide — Doc. 5798
SMTP.signal block>
In the above, signal block is replaced with the actual name of the e-mailer signal
block carrying on the conversation. This option should normally remain off
(unchecked).
Optional signal definitions
This frame lists optional signals which can be excluded from the signal block (and
from the congruent Intersystem Communications symbol on the control system
side). For further information on each of the optional signals listed in this frame,
refer to the “Signal Reference” on page 68. To exclude a (group of) signal(s) from
the signal block, either uncheck its checkbox or enter a zero (or blank) into its
textbox.
Using “Send e-Mail” SIMPL symbol
This option is a convenience feature. Checking it forces the selection of optional
signals to conform to the Send e-Mail SIMPL symbol (used in place of an
Intersystem Communications symbol). This option is checked in the figure above,
which means that the optional signals are forced to the following definitions:
Optional Signal
Send e-Mail
symbol value
SetParm
n
where n = 1 to: 4
LookupParm
n
where n = 1 to: 4
Shortcut
n
where n = 1 to: 16
Status
undefined
ErrString, ErrNumber, and ErrTrigger defined
None of these signals definitions can be altered so long as the Using “Send e-Mail”
SIMPL symbol option is checked.
e-Mailbox Signal Block Options
Selecting DEMO4 and clicking the Modify… button opens the e-Mailbox Signal
Block Definition window.