Specifications

Crestron e-control Mail SW-MAIL
11 •• Introduction Installation & Reference Guide — Doc. 5798
Leading Specifications
Specifications Table
SPECIFICATIONS DETAILS
SWSERVER.EXE
(included with this package)
Version 1.4
CNMS/RACK Operating System Version 3.18.12 or later
CNMSX/RACKX Operating System Version 5.09.25 or later
CNMSX/RACKX Monitor Version 5.09.25 or later
CNMSX/RACKX TCP/IP Stack Version 5.09.10 or later
CNX Gateway Version 2.08.04 or later
SIMPL™ Windows® Version 1.4 or later; or
Version 1.3 with Symbol Library
Update 067 or later
VisionTools™ Pro (VT Pro-e) Version 2.0.8.2 or later
Requirements
The server should meet these minimum system requirements.
Windows 95/98/NT Operating System hardware requirements
32 MB RAM
100 MB hard drive space
133 MHz or faster Pentium processor
A faster processor is recommended for serving multiple connections
simultaneously
800 x 600 or higher screen resolution
COM ports
Required to make serial (RS-232) connections to control systems (one
port per control system). (See Cable requirements below.)
Network Interface Card
Required to make EtherNet connections to control systems. Also
required in order to contact an e-mail host server via EtherNet
connection.
Dial-up connection
Alternate means of contacting an e-mail host server via TCP/IP. (See
Appendix F for configuration information.)
TCP/IP sockets
(These are software constructs provided by your operating system. The
maximum number of sockets is operating system dependent.)
Server requires one socket per server–control system connection
Required for EtherNet control system connections only.
CNX Gateway (see below) requires one socket + one additional socket per
server–control system connection