Specifications

ManualsBrandsCrestron ManualsComputer equipmentSurround Sound Tuning Kit

Crestron Adagio

AMS Media System

• Follow the onscreen instructions for identifying the device. After

identifying the device, the AMS will prompt for the next room’s control

device.

NOTE: If a device is not identified within two minutes, the AMS will

indicate that the keypad was not found. Try again by pressing the soft

button labeled Yes or cancel the process by selecting the soft button labeled

Abort.

• Repeat the procedure until control devices for all of the specified rooms

(refer to page 49) have been identified.

• Press MENU to return to the Installer Tools menu.

Load APADs

APAD devices may need to be programmed to work with the AMS. If a connected

APAD does not display controls for the AMS, perform the following:

• Open Installer Tools as described on page 41, select Load APADs, and

press the ENTER button.

Load APADs Warning

Warning:

All APADs will be

loaded with default

functionality. Continue?

SOURCE

ROOM

HOUSE

SURRND

THEATER

DISPLAY

Yes No

• Press the soft button labeled Yes to proceed and load the required files to

connected APADs or press No to cancel.

About

This screen allows you to view information about the AMS.

• Open Installer Tools as described on page 41, select About, and press the

ENTER button. The IP address, IP mask, and Hostname of the AMS are

displayed on the LCD.

About

System Information

Addr: 195.168.121.248

Mask: 255.255.255.0

Hostname: AMS-00107B050025