Specifications

Crestron ST-CS Current Sensor Module
File transfer | Send Program Command
3. The “Send Program” window appears as shown after this step. Click
Browse, locate the completed file (.spz for PRO2) and click Open. This
displays the program’s header information and enables one or both of the
What to Send check boxes. If the program does not contain any SIMPL+
modules, only the SIMPL Program check box is enabled. If it does contain
SIMPL+ modules, then the SIMPL+ Program(s) check box will also be
enabled. Select one or both check boxes and then click Send Program to
begin the transfer.
NOTE: Refer to the respective Operations Guide for control system details about the
other fields in the “Send Program” window.
“Send Program” Window
4. To verify that the program has been transferred successfully, select
Diagnostics | Report Program Information. This should display a
window that provides details about the current program loaded into the
control system.
Problem Solving
Troubleshooting
The following table provides corrective action for possible trouble situations. If
further assistance is required, please contact a Crestron customer service
representative.
Operations Guide – DOC. 5677A Current Sensor Module: ST-CS • 17