Specifications

Crestron ST-CS Current Sensor Module
from the Downloads | Product Manuals section of the Crestron website
(www.crestron.com). Refer to the following figure for a typical connection diagram
when uploading files.
NOTE: Use a standard DB9 male to female “straight-through” cable.
Typical Connection Diagram when Uploading
NET
G24 ZY
DB9 Cable
Serial Port
Computer Port
PC
Control
Processor
ST-CS
ST-CNB Cable
CRESTRON ELECTRONICS INC. N.J. 07626
NET
12VDC
.5A
NET
POWER A POWER B
50-60HZ
COMBINED
OUTP UT
10A MAX
90-125VAC
POWER IN
1. Open the Crestron Viewport.
Either launch the standalone version of Viewport, or start SIMPL
Windows, and from the menu bar, select Tools | Viewport.
2. Refer to the following illustration. From the Viewport menu, select Setup |
Communications settings (alternatively, press Alt+D) to open the “Port
Settings” window.
Setup | Communications Settings Command
3. Select RS-232 as the connection type. Verify that an available COM port
(COM 1 is shown after this step) is selected, and that all communication
parameters and necessary options from the “Port Settings” window are
selected as shown after this step. Click the OK button to save the settings
and close the window.
Operations Guide – DOC. 5677A Current Sensor Module: ST-CS • 15