Specifications

Crestron ST-1550C 1-Way Wireless RF Touchpanel
“Device Settings” Window for the CNRFGWA
NOTE: Recall that in both the ST-CP and the MC2W configurations, the
CNRFGWA has a fixed NET ID, which cannot be changed.
Similarly, expand the system tree in the lower pane and double-click the ST-1550C
icon to open the “Device Settings” window for the touchpanel. Select the RF/IR ID
tab to change the touchpanel RF ID, as shown in the following figure. For more
information on setting the RF/IR ID, refer to “Interface Screen”on page 11.
NOTE: The hardware and software settings of the RF ID must match. Although the
device setting window in SIMPL Windows allows choices through the range of two-
digit Hexadecimal numbers from 01 through FE, the RF ID setting for the hardware
is limited to numbers in increments of the most significant digit (i.e., 00, 10, 20).
Since 00 is not a valid selection in SIMPL Windows, the RF ID number is limited to
the fifteen numbers 10, 20, 30, 40, . . .F0.
Touchpanel “Device Settings” Window
ST-1550C Symbol in Programming Manager
Programming Manager is where programmers “program” a Crestron control system
by assigning signals to symbols. The following diagram shows the ST-1550C
symbol in the SIMPL Windows’ Programming Manager.
Operations Guide – DOC. 6096A 1-Way Wireless RF Touchpanel: ST-1550C • 15