Specifications

1-Way Wireless RF Touchpanel Crestron ST-1550C
Setup
Applying Power
The touchpanel can be powered via an external AC power pack, while resting in the
ST-DSN, or via the ST-BTPN. Each of these supplied items has an Operations Guide
which details proper usage. Refer to the table below for the required document
number. This table does not account for the latest revision letter of each document.
NOTE: The battery can be charged only if the touchpanel is in the docking station.
The touchpanel will function when powered by the external power pack, but this
configuration will not charge the battery.
ST-1550C Power Source Options
POWER SOURCE OPTION MODEL
DOCUMENT
NUMBER *
Battery Pack ST-BTPN 6088
Docking Station ST-DSN 6095
Domestic External Power Pack or PW-1215 5762
International External Power Pack PWI-1215 5763
* The latest revision may have a revision letter after the document number (e.g., 6088A).
Identity Codes
The ST-1550C touchpanel uses two distinct types of identity codes: Cresnet identity
(NET ID), and RF ID. These codes are assigned to the touchpanel from the Interface
Submenu when the unit is configured. Refer to “Interface” on page 11. For the
touchpanel to be identified within the Cresnet system, these assignments must match
assignments made in the SIMPL Windows program.
NET ID
Every equipment and user interface within the Cresnet system requires a unique NET
ID. The NET ID is a two-digit hexadecimal number that can range from 03 to FE.
The NET ID of the unit must match the NET ID specified in the SIMPL Windows
program. The NET ID is used when the touchpanel is wired directly to the control
system during uploading a VisionTools
™
Pro-e (VT Pro-e) project or upgrading the
touchpanel firmware.
RF ID
Every ST-1550C touchpanel communicating with a Cresnet control system via an
ST-CP or CNRFGWA requires a unique RF ID to secure RF communications. There
are 15 useable codes for multiple touchpanel(s) ranging from 01 to 0F (hexadecimal
number). The RF ID of the unit must match the RF ID specified in the SIMPL
Windows program.
NOTE: Do not set the RF ID to “00”; it is not supported in SIMPL Windows.
6 • 1-Way Wireless RF Touchpanel: ST-1550C Operations Guide – DOC. 6096A