Specifications

Crestron QM-RX QuickMedia™ Receiver

Installer’s Toolbox “Address Book” Window – Serial Setup

3. After setting the correct parameters, click OK to return to the

Installer’s Toolbox main window.

4. Click Tools | Network Device Tree to display the devices in the

system.

TCPIP Connection to Control Processor

1. Ensure that all devices are connected to the control processor. For

TCP/IP, use CAT5 straight through cables with 8-pin RJ-45 connectors

to connect the LAN port on the control processor and the LAN port on

the PC to the Ethernet hub. Alternatively, you can use a CAT5

crossover cable to connect the two LAN ports directly, without using a

hub. The following table illustrates pinouts for straight through and

crossover RJ-45 cables. Pins 4, 5, 7, and 8 are not used.

Operations Guide – DOC. 6333 QuickMedia™ Receiver: QM-RX ●