Specifications

QuickMedia™ Receiver Crestron QM-RX

QM Network Wiring

For the QuickMedia transport, use CRESCAT-QM.

The aggregate cable length from transmitter to receiver cannot have a delay

skew of more than 22 ns for a given signal path originating at a QM transmitter

and terminating at a QM receiver. The aggregate cable length must not exceed

328 feet.

When connecting multiple QM devices, the route between a QM origination

point (transmitter) and a QM endpoint (receiver) cannot have more than two

midpoints (e.g., QM-MD7x2 or other QM switchers). Refer to the following

diagram when configuring a QM network.

QM Network Topology

Installer’s Toolbox

The Installer's Toolbox (replacement for Crestron Viewport, you may continue

use Viewport if desired) is a broad-based software package that accomplishes

multiple system tasks, primarily using an RS-232 or TCP/IP connection between

a PC and one or more Crestron control systems.

You can use the Installer's Toolbox to:

• Observe system processes.

• Upload operating systems and firmware.

• Upload programs and touchpanel projects.

• Set or change device Network IDs.

• Change serial numbers.

• Run scripts to automate tasks.

• Perform system diagnostics, and much more.

The Installer's Toolbox allows you to perform these functions using simple

graphical views and click and drag methods.

● QuickMedia Receiver: QM-RX Operations Guide – DOC. 6333