Installation guide

Crestron QM-FTCC-TPS4 FlipTop Touchpanel Computer Center
Tools Required
• Phillips screwdriver
• Small flat-blade screwdriver (for connecting the VGA cable)
The cable support plate must be installed before mounting the QM-FTCC-TPS4 to a
surface. The cables are looped through the cable support plate.
1. Place the bushings on the cables (six bushings supplied). Use the large
bushing for the VGA cable.
2. Thread the cables through the appropriate slot on the plate.
3. Snap the bushings into the plate slots.
4. Feed all the excess cable through the opening.
5. Attach the plate using the four #4 x ¼ screws supplied.
6. Connect the cables to the appropriate connector on the rear of the unit.
7. The cables may be secured to the bottom bar using the supplied tie wraps.
Cable Management Plate Installation
(4) #4 x 1/4 LG Black Screws
Bushings
Cable Support Plate
Operations & Installation Guide – DOC. 6393 FlipTop Touchpanel Computer Center: QM-FTCC-TPS4 • 17