Installation guide

FlipTop Touchpanel Computer Center Crestron QM-FTCC-TPS4
QM
8
1
This eight-pin RJ-45 transport port allows connection of the QuickMedia cable.
It carries audio, video, and microphone signals over CresCAT-QM cable to a
QuickMedia receiver or switcher. For more information on QuickMedia refer
to page 3.
RJ-45 QuickMedia Connector Pin Assignments
RJ-45 PIN
NUMBER
WIRE COLORS
(EIA 568B)
QM ASSIGNMENT
RGB, COMPONENT, AND AUDIO
1 WHITE/ORANGE - RGB RED (- CHROMINANCE) (-P
R
)
2 ORANGE + RGB RED (+ CHROMINANCE) (+P
R
)
3 WHITE/GREEN - RGB GREEN (- LUMINANCE) (-Y)
4 BLUE + AUDIO
5 WHITE/BLUE - AUDIO
6 GREEN + RGB GREEN (+ LUMINANCE) (+Y)
7 WHITE/BROWN - RGB BLUE (- COMPOSITE) (-P
B
)
RJ-45 MALE CONNECTOR
8 BROWN + RGB BLUE (+ COMPOSITE) (+P
B
)
NOTE: Always use CresCAT-QM cable to make QuickMedia connections.
NOTE: CresCAT-QM siamese cable includes four wires for making Cresnet
connections.
COMPUTER
5
15
10
1
6
11
COMPUTER
This female DB15HD connector is used for connecting a computer’s RGB
video output to the presentation system. This port can automatically detect the
presence of an H-sync video signal to support RGBHV and RGBS, and
component video detection by sensing the green video signal on pin 2 to
support RGsB and Y, P
B
, P
R
. Refer to the following table for the DB15HD
connector pin-assignments.
• 75 Ω terminated (R, G, B)
• Maximum input voltage 1 V
p-p
• Maximum H and V Sync: 5.0 V
p-p
into 1 kΩ
RGB DB15HD Pin Assignments
PIN FUNCTION PIN FUNCTION
1 Red Video 9 No Connect
2 Green Video 10 Ground
3 Blue Video 11 No Connect
4 Reserved 12 Monitor Sense 1
5 Ground 13 Horizontal Sync
6 Red Ground 14 Vertical Sync
7 Green Ground 15 Monitor Sense 2
8 Blue Ground
10 • FlipTop Touchpanel Computer Center: QM-FTCC-TPS4 Operations & Installation Guide - DOC. 6393