Installation guide

Crestron QM-FTCC-TPS4 FlipTop Touchpanel Computer Center
Controls and Ports (Top)
Buttons
The QM-FTCC-TPS-4 touchpanel has 10 hard buttons; five on each side of the
display. The buttons are backlit with white LEDs; brightness is program
adjustable. The buttons can be programmed to automate frequently used
functions.
AC Outlet
125V – 50/60Hz 10A
The 3-prong grounded AC outlet is rated 125 VAC @ 10 Amps, 50 – 60 Hz.
The international version (QMI-FTCC-TPS-4) has a bezel that accepts an
adaptor receptacle, and three wires that connect to the adaptor; blue, brown, and
green with a yellow stripe.
The international AC outlet is rated MAX 250 VAC @ 10 Amps, 50 – 60 Hz.
Refer to “Appendix A” on page 42 for a complete list of international
receptacles and applicable countries.
MAX 250V~50/60Hz 10A
Ports (Underside)
MIC 1 / MIC 2
These two 5-pin 3.5 mm detachable terminal blocks provide two microphone
and line level audio inputs.
• Balanced microphone input level: -60 to –20 dBV nominal
• Balanced line input level: -28 to +12 dBV, 4 V
RMS
maximum
• Unbalanced input level: -34 to +6 dBV, 2 V
RMS
maximum
• Microphone input impedance: 10 kΩ,
accepts balanced microphones 60 to 600 Ω
• Line input impedance: 22 kΩ (balanced), 11 kΩ (unbalanced)
• Phantom power: 10 mA (total) at 48 VDC, software enabled for both
inputs
• Mic level indicators (via software): 20 dB below clipping (Norm), 6 dB
below clipping (Overload)
• Mic Input Gain: 0 to 100% (0 to 40 dB) plus mute
• Gate level (threshold): 0 to 100%
• Attack: 1 to 100 ms
• Decay (release): 1 to 5000 ms
• Analog to Digital conversion: 24-bit, 48 kHz
AUDIO
This 3.5 mm mini-jack is provided for the computer sound card output. The
connector provides an unbalanced stereo line-level audio input (maximum
input level 1 V
RMS
@ 10 kΩ).
AUDIO
Operations & Installation Guide – DOC. 6393 FlipTop Touchpanel Computer Center: QM-FTCC-TPS4 • 9