System information

Reference Guide Crestron 2-Series Control System
4 • 2-Series Control Systems Reference Guide – DOC. 6256A
• Run scripts to automate tasks.
• Perform system diagnostics, and much more.
Crestron Toolbox allows you to perform these functions using simple graphical
views and click and drag methods.
Crestron Toolbox also contains the Network Analyzer and Test Manager (expected
2Q 2006) utilities.
Network Analyzer
The Network Analyzer utility helps to identify Cresnet
®
network problems that can
be caused by faulty devices, electrical shorts, or breaks in network wiring. Network
Analyzer takes a sample of the voltage levels on the Cresnet "Y" and "Z" wires.
Network Analyzer is launched from within Crestron Toolbox by clicking the
Network Analyzer icon
.
For more information on Network Analyzer, refer to “Network Analyzer” on page
75.
Test Manager
The Test Manager is a utility for testing and debugging a SIMPL Windows program,
by monitoring the status of selected signals in real time. Test Manager can test any
program that has been compiled and uploaded to the control system.
Test Manager is launched from within SIMPL Windows by clicking the Test
Manager button or by selecting Tools | Test Manager. Test Manager can also be
opened as a standalone program.
For more information on Test Manager, refer to “Test Manager” on page 71.
Viewport (Limited Use)
Where noted in this guide, the Crestron Viewport can be used to perform certain
functions
Viewport is available as a pull-down command from SIMPL Windows and VT Pro-e
(Tools | Viewport) or as a standalone utility. The Viewport utility performs multiple
system tasks, primarily via an RS-232 or TCP/IP connection between the control
system and a PC. It is used to observe system processes, upload new operating
systems and firmware, change system and network parameters, and communicate
with network device consoles and touchpanels, among many other tasks. Viewport
can also function as a terminal emulator for generic file transfer. All of these
functions are accessed through the commands and options in the Viewport menus.
NOTE: Except where noted, Crestron Toolbox should be used.