System information

Crestron 2-Series Control Systems Reference Guide
Reference Guide – DOC. 6256A 2-Series Control Systems • 39
Expand the device to view the available slots in the MP2/MP2E remote processing
symbol. The following diagram shows the available slots of an MP2E operating in
slave mode.
Device Detail
NOTE: The C2Net-Device and C2ENET-Device slots are never available on a
control system operating in slave mode. All other slots may be configured as
described in the slave system’s respective manual. Slave devices do not control
networks.
Configuring a Control System as an Ethernet Slave Device
Continuing with our PRO2 example, add an Ethernet card to the Z-Bus by right-
clicking slot 8. Select Add item to: “C2Z Card Slot” and add a C2ENET-1 or
C2ENET-2 as shown in the following diagram.
Adding a C2ENET Card
To incorporate a control system as an Ethernet system slave, drag the Remote
Ethernet Processing symbol for the control system to be added from the Ethernet
Control Modules | Ethernet Modules (Crestron) | Ethernet Remote Processing
Modules folder of the Device Library and drop it in the System Views.
The System Views shows the MP2E as a slave device in slot 8 with an IP ID of 50
(assuming that no other C2ENET devices are present as shown in the following