System information

Crestron 2-Series Control Systems Reference Guide

Reference Guide – DOC. 6256A 2-Series Control Systems • 35

“Cresnet ID” Window

Select Cresnet ID 02 to set the control system to the Cresnet Master mode and click

OK or Apply. The control system will automatically reboot.

NOTE: The control system must be detached from Cresnet before changing a slave

to a master.

NOTE: If a control system is operating in the Cresnet Master mode, the Device IDs

section of the “System Information” window will indicate a Cresnet ID value of 02.

NOTE: Only one Cresnet master control system can exist in a network.

Cresnet Slave Mode

After establishing communications with the control system, select Functions |

Cresnet ID… to open the “Cresnet ID” window.

“Cresnet ID” Window

Select any Cresnet ID from 03 to FE to set the control system to the Cresnet Slave

mode and click OK or Apply. The control system will automatically reboot.

NOTE: The control system must be detached from Cresnet before changing the

master to a slave.

NOTE: If a control system is operating in the Cresnet Slave mode, the Product Info

section of the “System Information” window will indicate the control system as a

“Cslave”. The Device IDs section of the “System Information” window will indicate