System information

Reference Guide Crestron 2-Series Control System
34 • 2-Series Control Systems Reference Guide – DOC. 6256A
Configuring the Control System
System Requirements
To operate a control system as a master or slave device, the following control system
update files and programming software are required:
Software Requirements for Master-Slave Operations
SOFTWARE
*
VERSION NUMBER SUPPORTED MODES
2-Series Control
System Update Files
AV2
C2N-DVP4DI
CNX-DVP4
CP2
CP2E
MC2E
MC2W
MP2
MP2E
PAC2
PRO2
QM-RMC
QM-RMCRX(-BA)
RACK2
Version 3.044 or later
Version 3.060 or later
Version 2.006 or later
Version 3.044 or later
Version 3.044 or later
Version 3.050 or later
Version 3.050 or later
Version 3.050 or later
Version 3.050 or later
Version 3.044 or later
Version 3.044 or later
Version 3.052 or later
Version 3.052 or later
Version 3.044 or later
Cresnet or Ethernet
Cresnet or Ethernet
Cresnet or Ethernet
Cresnet
Cresnet or Ethernet
Cresnet or Ethernet
Cresnet
Cresnet
Cresnet or Ethernet
Cresnet or Ethernet
Cresnet or Ethernet
Ethernet
Cresnet or Ethernet
Cresnet or Ethernet
SIMPL Windows
Version 2.04.11 with
library update 232 or
version 2.04.14 or later
N/A
Crestron Toolbox Version 1.01.06 or later N/A
* The latest versions can be obtained from the Crestron website. Refer to NOTE which follows.
NOTE: Crestron software and any files on the website are for Authorized Crestron
dealers and Crestron Authorized Independent Programmers (CAIP) only. New users
may be required to register to obtain access to certain areas of the site (including the
FTP site).
Cresnet Master-Slave Modes
Every device (including a control system) is assigned a unique Cresnet ID (Net ID).
Master control systems always use Net ID 02. If a control system is to be used as a
slave device, its Net ID must be changed to a hexadecimal value ranging from 03 to
FE.
Use Crestron Toolbox to establish communications between the control system and
your PC as described on page 5. After establishing communications, Crestron
Toolbox can be used to set the Net ID and change a control system from a master
system to slave device, and back.
Cresnet Master Mode
After establishing communications with the control system, select Functions |
Cresnet ID… to open the “Cresnet ID” window.