System information

Crestron 2-Series Control Systems Reference Guide
Reference Guide – DOC. 6256A 2-Series Control Systems • 21
List of Acceptable Commands for the 2-Series Dual Bus Control System (Continued)
COMMAND DESCRIPTION
SHOWEXTRAERRORS Enables extended error reporting
SHOWHW Display hardware configuration
SHOWPORTMAP Display the portmap from the NAT table
SSL Configure the SSL options
STANDBY Put the DVP4 into standby mode
STBYTO Set the standby timeout for DVP4
SYSTEM Xmodem download new firmware
TELNETPORT Enable/disable connections on the Telnet port (23)
TESTDNS Perform a DNS lookup on a given name
TIMEDATE Set the time and date
TOUCH Set the touch input for a DVP4
TYPE Display file contents
UPLOAD Load file into cresnet device
UPTIME Display the amount of time the system has been running
USERPROGCMD Send a string from the console to the user program
USERPASSWORD Enter the password to protect user pages
VERSION Print version to console
WEBINIT Initialize Webserver default file
WEBPORT Specify the port for the Webserver
WEBSERVER Enable/disable Webserver
WHO Display a list of the active console and gateway connections
XGETFILE Use Xmodem to retrieve file from system
XONXOFF Set/clear software handshaking
XPUTFILE Use Xmodem to transfer file to ROM
Processor Groups
At the time this document was released, Crestron offered 14 different 2-Series
processors. Selection of a processor depends on the application of the system.
Commands may only be supported on a ‘subset’ of 2-Series processors or processor
group. The table below lists the specific processors that belong to a processor group.
Breakdown of Processor Groups
PROCESSOR GROUP SPECIFIC PROCESSORS*
All 2-Series Processors
PRO2, AV2, PAC2, RACK2, CP2, CP2E, MP2, MP2E, MC2W,
MC2E, CNX-DVP4, C2N-DVP4DI, QM-RMC, and
QM-RMCRX(-BA)
Audio Processors MP2 and MP2E
Ethernet Processors
PRO2, AV2, PAC2, RACK2, CP2E, MP2E, CNX-DVP4, C2N-
DVP4DI, QM-RMC, and QM-RMCRX
Dual Ethernet Processors PRO2, AV2, PAC2, and RACK2
Compact Flash Processors PRO2, AV2, PAC2, RACK2, CNX-DVP4, and C2N-DVP4DI
Cresnet Processors
PRO2, AV2, PAC2, RACK2, CP2, CP2E, MP2, MP2E, MC2W,
MC2E, CNX-DVP4, C2N-DVP4DI, and QM-RMCRX(-BA)
Display Processors CNX-DVP4 and C2N-DVP4DI
Plug-in Card Processors PRO2, AV2 (with card cage), PAC2, and RACK2
Front Panel Processors PRO2 and RACK2
QuickMedia Processors QM-RMC and QM-RMCRX(-BA)
* While not considered a 2-Series processor, there are console commands that can only be used when
a C2N-NPA8 is attached to the control system.