System information

Reference Guide Crestron 2-Series Control System
20 • 2-Series Control Systems Reference Guide – DOC. 6256A
List of Acceptable Commands for the 2-Series Dual Bus Control System (Continued)
COMMAND DESCRIPTION
HOSTNAME Set the host name to be used in a DNS/DHCP environment
I2CERROR Enable reporting of I2C errors
ICMP Enable/disable response to ICMP ping requests
INFO Print software capabilities
INITIALIZE Clear internal file system
INPUT Set the DVP4 input resolution
IPADDRESS Set IP address
IPMASK Set IP subnet mask
IPTABLE Display IP table
ISDIR Check to see if path is a directory
KILLSOCKET Terminate a TCP console connection
LISTDNS Displays a list of DNS servers
MAKEDIR Create a file directory on compact flash
MESSAGE Display a message on front panel screen
MODEMINITSTRING Displays and changes the modem initialization string
NATENABLE Enable/disable Network Address Translator (NAT)
NATREMOTE
Enable/disable configuring the Network Address Translator (NAT)
from the WAN (LAN A) port
NPA Access Network Poll Accelerator Utilities
NVRAMCLEAR Clear the program portion of NVRAM
NVRAMDISK Establish and format a file disk in NVRAM
NVRAMGET Retrieve the contents of NVRAM using XMODEM from the system
NVRAMPUT Load the contents of NVRAM using XMODEM to the system
NVRAMREBOOT
Enables/disables storing special reboot information when the
processor unexpectedly reboots.
OUTPUT Set the DVP4 output resolution
PASSWORD Set console password
PING Perform IP ping test on remote node
PROGRESET Reloads and restarts the program
PROGUPTIME Display the amount of time the program has been running
RAMFREE Show available file space in the ram file system
REBOOT Perform system reboot
REMDNS Remove a DNS server from the list
REMMASTER Remove a master entry from IP table
REMOVEDIR Delete a file directory on compact flash
REMPORTMAP Remove a port map from the NAT table
REMSLAVE Remove a peer/slave entry from the IP table
REPORTCRESNET Show all devices on the main Cresnet leg
RESTORE Restore factory defaults
RTSCTS Set/clear hardware handshaking
SAVEPARAM Save system parameters
SDEBUG Monitor packets to/from logic
SECURECIPPORT Set the secure (SSL) port for CIP
SECURECTPPORT Set the secure (SSL) port for CTP
SECUREWEBPORT Set the secure (SSL) webserver port
SELFTEST Initiate the self test procedure
SENDKEY Add e-Control2 activation key
SENDMODEMINITSTRING Sets/clears modem initialization
SERIAL Set serial communication parameters
SETUP Enter the DVP4 setup pages
(continued on next page)