System information

Crestron 2-Series Control Systems Reference Guide
Reference Guide – DOC. 6256A 2-Series Control Systems • 19
Commands are case insensitive and can be entered from the appropriate prompt (i.e.,
AV2, PRO2, DVP4DI, etc.). Help on individual commands is available by typing the
command followed by a "?" (i.e., ADDMASTER ?). The following table lists
acceptable commands alphabetically and provides a brief description of each
command. Refer to “Appendix C: Console Command Listing” on page 91 for
detailed information.
NOTE: The commands listed are not applicable to every processor. Refer to
“Appendix C: Console Command Listing” on page 91 to determine if the command
is applicable to your processor.
List of Acceptable Commands for the 2-Series Dual Bus Control System
COMMAND DESCRIPTION
ADDDNS Add a DNS server to the static list
ADDMASTER Add an entry to IP table to act as a master to the current system
ADDPORTMAP Add a port map to the NAT table
ADDSLAVE
Add an entry to IP table to act as a peer or slave to the current
system
AUTONEGOT Set auto negotiation for Ethernet device
BROADCAST Enable/disable the broadcasting of error messages
BYE Close user session
CALTOUCH Start DVP4 touchscreen calibration
CARDS Display cards detected in system
CD Change the file directory
CFAUTORUN
Enables an automatic start of programs when compact flash is
inserted or extracted
CFLOGERR Enable logging errors to compact flash
CFPROJDIRS Display a list of project directories on compact flash
CFTRANSFER Transfer a project to/from compact flash
CIPPORT Specify the port for the CIP interface
CLEARERR Clears the current error log
CNETID Set the Cresnet ID of the system
COMPACT Remove invalid files from system
COMCONSOLEMODE Sets operating mode of COM B
CTPPORT Specify the port for the CTP console
CURSOR Set the cursor option for the DVP4
DEFROUTER Set default router
DELETE Delete file(s)
DHCP Enable/disable dynamic IP address via DHCP
DIR Display files in directory
DOMAINNAME Enter a domain name to be used in DHCP
ECHO Enable/disable character echoing
EEPROM Displays the parameters stored in EEPROM
ERRLOG Prints the current error log
ESTATUS Displays the status and parameters for the Ethernet card
ETHERNET Enable/disable Ethernet
ETHERTEST Perform diagnostic test on the Ethernet card
FPPASSWORD Set front panel password
FREE Show available file space
GETCODE Retrieve the code needed for e-Control2 activation
GETFPLINE Show LCD front panel display on the console
HEAPFREE Show available RAM space
HELP Display help screens
(continued on next page)