System information

Crestron 2-Series Control Systems Reference Guide
Reference Guide – DOC. 6256A 2-Series Control Systems • 169
System View of TPS Series Panel Control Systems with Three Ethernet Devices
Double-click on an Ethernet Device to rename the device and set the Device ID.
Device Settings for Ethernet Device for TPS Panels
Select an IP ID and enter the IP address for the classroom control system that will be
communicating with the touchpanel. Repeat this for each Ethernet device that will
communicate with the control room touchpanel.
NOTE: When used for Join Number Remapping, IP ID becomes the Device ID. An
IP ID may be entered in the above window for documentation purposes only. The IP
ID must be set in the IP table from Crestron Toolbox.
Signals
The press and feedback signals for each of the classrooms are present on the symbol
for Slot 1 of the TPS Series Panel Control System as shown in the following
diagram. These signals are used to receive physical presses on the control room
touchpanel and provide feedback when a button is pressed on the touchpanel.