System information

Reference Guide Crestron 2-Series Control System
168 • 2-Series Control Systems Reference Guide – DOC. 6256A
Room Camera Head Control Program
The Control Room Program
The touchpanel connected to the C2ENET-1 device in slot 8 is used to select the
classroom to be controlled (press numbers 46, 47, and 48). Refer to the following
diagram. The individual camera head presses and feedbacks for each classroom
reside in the JNR program.
Room Selection Presses and Feedback on Control Room Touchpanel
The JNR Program
The JNR program will be used to route touchpanel presses 1 through 15 to Device ID
20, 16 through 30 to Device ID 21, and 21 through 45 to Device ID 22.
System Configuration
In Configuration Manager, add an Ethernet Device for TPS Panels for each
classroom to slot 22 of the TPS Series Panel control system. Refer to the following
diagram.