System information

Reference Guide Crestron 2-Series Control System
160 • 2-Series Control Systems Reference Guide – DOC. 6256A
panel is an output from the TPS Screen Interface symbol and a corresponding input
to the TPS Cresnet Interface symbol. Due to the default behavior of remapping, the
remap program does not need the inputs and outputs of the touchpanel in the PRO2
program, just the inputs and outputs that are to be remapped.
TPS Cresnet Interface Symbol
NOTE: In the Cresnet Interface Symbol, fb signals are sent by the touchpanel over
Cresnet and press signals are received by the touchpanel over Cresnet.
Cresnet Example 1:
To send a signal to a control system over Cresnet that indicates that the remote
touchpanel’s key-click function is on, connect the BEEP_ON-FB signal of the
Audio Reserved Joins symbol to an fb input on the TPS Cresnet Interface. Refer to
the following illustrations.
TPS Screen Interface (Audio Reserved Joins) Symbol
TPS Cresnet Interface Symbol
In the control system program, a signal must be put on press50 of each touchpanel in
the Cresnet system as shown in the following diagram. The press and feedback
numbers of the TPS Cresnet Interface Symbol must match the respective press and
feedback numbers of touchpanels in the control system program. Signal names do
not have to match.
TPS Touchpanel Interface Symbol in a Control System