System information

Crestron 2-Series Control Systems Reference Guide
Reference Guide – DOC. 6256A 2-Series Control Systems • 155
Programming
Creating a JNR Program
To create a program that uses JNR, the following firmware and software
requirements must be met:
• Isys touchpanel firmware (version 1.017 or later)
• 2-Series CUZ file (version 3.015 or later)
• SIMPL Windows (version 2.03.18 or later)
• VT Pro-e (version 2.3 or later)
• Crestron Toolbox (version 1.01.06 or later)
NOTE: To determine the firmware version on the touchpanel, refer to the
“Diagnostics Menu” section of the Isys touchpanel operations guide.
NOTE: The latest software and firmware versions can be obtained from the Crestron
website. Crestron software and any files on the website are for Authorized Crestron
dealers and Crestron Authorized Independent Programmers (CAIP) only. New users
may be required to register to obtain access to certain areas of the site (including the
FTP site).
Once the latest versions are loaded, create a SIMPL Windows program with the Isys
touchpanel as the control system. This will be the JNR Routing Table. SIMPL
Windows is the optimum environment for creating a JNR Routing Table as SIMPL
Windows is already used to route signals in a conventional control system program.
From the Control Systems folder in the Device Library of Configuration Manager,
select TPS Series Panel as shown in the following diagram, and drag it to System
Views.
Choosing an Isys Touchpanel within the Control System Folder