System information

Crestron 2-Series Control Systems Reference Guide
Reference Guide – DOC. 6256A 2-Series Control Systems • 149
Error Level Messages, W (continued)
MESSAGE DEFINITION
WaitForNewDisk:
Unable to open disk.
An error occurred in the WaitForNewDisk routine when trying to
initialize the new disk.
WakeListenTask:
unable to close
temporary socket.
Internal system error. Contact Crestron.
WakeListenTask:
Unable to connect to
wake up socket.
Internal system error. Contact Crestron.
WakeListenTask:
Unable to open
wakeup socket.
Internal system error. Contact Crestron.
WakeReadTask: Error
sending to wakeup
node: nn.
Internal system error. Contact Crestron.
WriteData: invalid
destination.
Internal system error. Contact Crestron.
X
MESSAGE DEFINITION
XmodemPurgePipe:
Error Resetting the
pipe.
Internal system error. Contact Crestron.
XmodemPutChar:
invalid source.
Internal system error. Contact Crestron.
XmodemToCompact
Flash: error writing to
file.
An error occurred writing to the compact flash.
XmodemToCompact
Flash: unable to
allocate buffer for
Xmodem xfer.
Internal system error. Contact Crestron.
Z
MESSAGE DEFINITION
Zero length packet
encountered from
Symbol/Device#
(Packet Printout).
(0068:####:0068)
This type of error is generally not seen, as lower-level driver layers
will prevent zero length packets from reaching logic. However, if
there is a network error (such as two devices with the same ID on
Cresnet, or a bad wiring problem) there is potential that this could
be seen. Two Masters on the same Cresnet network can also
cause errors like this.