System information

Reference Guide Crestron 2-Series Control System
146 • 2-Series Control Systems Reference Guide – DOC. 6256A
Error Level Messages, S (continued)
MESSAGE DEFINITION
SystemUpgrade:
Attempt to load invalid
software
An attempt was made to upgrade the system with a file that was not
compatible with the current hardware.
SystemUpgrade: File
loaded does not
support current flash.
An attempt was modified to load a version of the firmware that does
not support the flash in the system. This happens when an older
version of firmware is sent to the system.
T
MESSAGE DEFINITION
TCP_ListenTask:
unable to set listen
socket flag.
Internal system error. Contact Crestron.
TCP_Read: error
closing socket.
Internal system error. Contact Crestron.
TCP_Send: problem
writing data: nn.
Internal system error. Contact Crestron.
TCP_Send: socket
broken,
disconnecting.
A broken socket was detected during a TCP send.
TCP_Task: unable to
disable Nagle
algoritm.
Internal system error. Contact Crestron.
Timeout waiting for
SIMPL+ event task to
start in Module
Symbol/Device#.
(004A:####:004A)
Internal system error. Contact Crestron.
Too many calls to
SMSC111_Open.
Internal system error. Contact Crestron.
TPS_FileClose:
Attempt to close an
unopened file.
An attempt to close an unopened file. Bad file handle.
TPS_FileOpen: No
free file structures.
Too many files are currently open.
TPS_FindFirst:
Current task not a
registered file user.
The calling task has not registered as a file user. Should call
StartFileOperations if SimpPlus.
TPS_FindFirst: Illegal
Wildcard String. ? not
supported.
The ? wildcard character is not supported in the 2-series.
TPS_FindFirst: Invalid
Wildcard String. Too
many Wildcards.
The file system only supports a maximum of 2 wildcards in a file
specification.
Transient strings
cannot be used with
Serial RAM
Symbol/Device#.
(003B:####:003B)
Generally, a transient string (such as from a Serial Send) will be
automatically converted to a permanent string when connected to a
Serial RAM. However, if a 0 is put on the string input/output of a
Serial RAM, this error message can still occur. This is commonly
seen when a macro is programmed and a 0 is placed on a macro
input/output that ends up driving the string input/output.
TransmitPacket: Error
sending to CIP Node.
Status: nn.
Internal system error. Contact Crestron.
(continued on next page)