System information

Crestron 2-Series Control Systems Reference Guide
Reference Guide – DOC. 6256A 2-Series Control Systems • 143
Error Level Messages, P (continued)
MESSAGE DEFINITION
ProcessCIP_Packet:
Error sending Cresnet
Request Reject
Internal system error. Contact Crestron.
ProcessCIP_Packet:
Error sending Master
Query Response
Internal system error. Contact Crestron.
ProcessCIP_Packet:
Error sending
Revision Response
Internal system error. Contact Crestron.
ProcessCommand:
Error writing to
Console RxPipe.
Internal system error. Contact Crestron.
ProcessGatewayData:
No room for packet.
Data lost.
Data overrun error. The logic processor is not keeping up with the
web page.
ProcessGatewayData:
Out of handles for this
socket
A web page link established too many connections on one TCP
port.( >1024)
ProcessNewChar:
Error writing to
captured Rx pipe.
Status=xxx
Internal system error. Contact Crestron.
Project will not fit on
destination.
There is not enough room for the project transfer.
Q
MESSAGE DEFINITION
Que Error:
CeventSchedulerHelp
er::Entry()
(0015:####:0015)
Internal system error. Contact Crestron.
Que is Full: Could not
add signal “1” to the
Logic Processor
(0014:####:0014)
Internal system error. Contact Crestron.
Que is Full:
TimerExpired()
(0014:####:0014)
Internal system error. Contact Crestron.
Que is Full: Too many
transitions in a single
logic wave.
(0014:####:0014)
The maximum number of signals that can change in a single wave
is 5000. (a signal transition is a new value for a digital/analog/serial
signal)
R
MESSAGE DEFINITION
ReadData: Too many
characters to echo.
The Ethernet port received too many characters in one packet to
echo back.
ReadSplus: File
filename not found.
The system could not find the Simpl+ file specified. The program
should be resent.
ReadSplus: Incorrect
file format.
The Simpl+ file was corrupted. The program should be recompiled
and resent.
(continued on next page)