System information

Reference Guide Crestron 2-Series Control System
138 • 2-Series Control Systems Reference Guide – DOC. 6256A
Error Level Messages, I (continued)
MESSAGE DEFINITION
Invalid Error Message
####.
(0020:####:0020)
Internal system error. Contact Crestron.
Invalid format for Limit
Scaler
Symbol/Device#.
Valid formats are
#### through ####.
(006E:####:006E)
The Limit Scaler only accepts formats as shown in the error
message. If an invalid format is entered, this error message is
issued. IF this error message is issued, the Limit Scaler will NOT
perform any processing in response to transitions on its inputs.
Invalid IP ID #### in
CIP Transmission
Symbol/Device#.
(0047:####:0047)
The IP ID must be between 03 and FE (hex).
Invalid IR Data Index
for Symbol/Device#.
(0030:####:0030)
Internal system error. Contact Crestron.
Invalid join number
#### in ProtocolName
(0011:####:0011)
Internal system error. Contact Crestron.
Invalid Parameter
#### in Symbol
Symbol/Device#.
(001C:####:001C)
The specified parameter (starting at 0 and increasing linearly) is
considered invalid for the symbol. This can happen in a Serial
Demultiplexor (SDEMUX) symbol if the parameter is not in a valid
range. It can also happen if a SIMPL+ module has no internal
name specified (this should not happen; if it did it would be a
system or compilation error).
Invalid Signal Number
#### in Receive of
Intersystem
Communications
Symbol/Device#.
(004C:####:004C)
If an XSIG receives a signal that does not fit on its list, it will
generate this error. For example, the fiftieth digital input of an XSIG
goes high, but the receiving XSIG only has five outputs. This error
was removed in CUZ 3.000 and later due to the fact that it is
perfectly valid that an XSIG may receive an out-of-bounds signal
due to the use of the “Offset” option.
Invalid String ID ####
detected while
parsing input to Serial
Demultiplexor
(special)
Symbol/Device#.
(0044:####:0044)
The ID on the input string received does not match any ID byte in
the parameter field of the symbol.
Invalid String received
by Duple Decoder
Symbol/Device#
(String: ABCD).
(0023:####:0023)
The Duple Decoder checks to see if the incoming string is a
properly duple encoded string. If it does not match the proper
format, the error is issued along with the string received for
decoding. The valid Duple format is in the SIMPL Windows help for
the Duple Encoder/Decoder.
Invalid time stored.
Setting defaults.
The time stored in the real-time clock chip is invalid. The default
time is restored.
Invalid Transmit
Analog format #### in
Symbol/Device#.
(001F:####:001F)
The Transmit Analog symbol (TXA) has only a certain number of
valid formats. If the format is outside the legal range, this message
is printed.
InvalidateFile: failed
to (un)lock flash.
Internal system error. Contact Crestron.
(continued on next page)