System information

Crestron 2-Series Control Systems Reference Guide
Reference Guide – DOC. 6256A 2-Series Control Systems • 137
G
MESSAGE DEFINITION
Get_file_Xmodem:
max file size
exceeded.
The file received is too big for the internal buffer. Unable to send
file to internal flash.
GetCurrentDirectory:
Current task not a
registered file user.
The calling task has not registered as a file user. Should call
StartFileOperations if SimpPlus.
GetListSemaphore:
Error Obtaining
Semaphore.
Internal system error. Contact Crestron.
GetNewHandle:
Could not allocate
m_pNodeArrary.
Internal system error. Contact Crestron.
I
MESSAGE DEFINITION
I2C problem. Internal system error. Contact Crestron.
Illegal #chars
parameter value for
Serial RAM
Symbol/Device#.
(003A:####:003A)
Serial RAM (SMEM) symbols require a parameter value of 1 or
greater. This message is issued if 0 is used.
Illegal queue_size
value for Serial
Queue
Symbol/Device#.
Value will be
truncated to ####.
(003D:####:003D)
The Serial Queue symbol can only take in a maximum amount of
characters, which is specified in the error message. If the
parameter is too large, the parameter is truncated at the specified
value.
In CIP Transmission
Symbol/Device# IP ID
#### is not defined in
the IP table.
(0048:####:0048)
The specified IP ID does not match any entry in the IP table.
InitializeEthernetFrom
File: Illegal Portmap
Number.
A NAT port map number was detected in the file. The maximum
number of portmaps allowed is 32.
Internal buffer length
of #### exceeded in
Serial Pacer
Symbol/Device#.
(0046:####:0046)
The serial pacer symbol has a buffer of the specified number of
characters internal to it for holding data while it is pacing characters
to its output. If more data comes into the symbol than the
temporary buffer can hold, this error is issued. The existing data is
kept, and the new data that was to be added is dropped.
Internal Buffer
Overflow in Serial
Queue
Symbol/Device#.
(003E:####:003E)
Too many characters have come into the input of the specified
Serial Queue, and the internal buffer created cannot hold that many.
The buffer needs to be cleared before more characters can be
added, using the clear input on this symbol. If this error occurs, the
current contents will stay and the new input is discarded.
Invalid date format
#### in
Symbol/Device#.
(0035:####:0035)
The Serialize Date symbol specified has a format parameter that is
out of the legal range. Consult the SIMPL Windows help file for the
legal values.
Invalid DST format
#### in
Symbol/Device#.
(0034:####:0034)
The Clock Driver symbol specified has a Daylight Savings Time
parameter that is out of the legal range. Consult the SIMPL
Windows help file for the legal values.
(continued on next page)