System information

Reference Guide Crestron 2-Series Control System
130 • 2-Series Control Systems Reference Guide – DOC. 6256A
C
MESSAGE DEFINITION
CActiveSocket:
unable to clear active
socket flag
Internal system error. Contact Crestron.
CActiveSocket:
unable to set active
socket flag
Internal system error. Contact Crestron.
CActiveSocket::Read
Data: Error echoing
data
Internal system error. Contact Crestron.
Cannot create
CSMSC111_Device.
Internal system error. Contact Crestron.
Cannot create pipe for
Serial Pacer
Symbol/Device#.
(0064:####:0064)
Internal system error. Contact Crestron.
Cannot find any
Control Crosspoint
Routing symbols for
Equipment Crosspoint
Routing symbols to
connect to.
(004E:####:004E)
For Equipment Crosspoint symbols to work, there must be at least
one Connection Crosspoint routing symbol in the program.
Cannot find any
Equipment Crosspoint
Routing symbols for
Control Crosspoint
Routing symbols to
connect to.
(004D:####:004D)
For Connection Crosspoint symbols to work, there must be at least
one Equipment Crosspoint routing symbol in the program.
Cannot move
[up|down|left|right]
greater than ####
pixels in Mouse String
Symbol/Device#.
(0045:####:0045)
The mouse can only move a certain number of specified pixels in
the specified direction. The analog input to the mouse symbol is
attempting to drive it beyond the bounds.
Cannot Start Task.
(0013:####:0013)
Internal system error. Contact Crestron.
Cannot transmit
packet: (partial packet
printout) to
symbol/device#.
Packet is too large.
(0012:####:0012)
This message is rare and usually will result if you have deep levels
of hierarchy in a program or large serial strings being sent to a
device that is under hierarchy (such as a ST-COM that is
connected to the Cresnet port of a CEN-TVAV that is an Ethernet
slave).
Can't add NULL
device to
symbol/device#.
(0008:####:0008)
Internal system error. Contact Crestron.
CClientConnectionTa
sk: Unable to connect
to TCP server
The TCP client was unable to establish a connection with its
designated TCP server.
CClientConnectionTa
sk: Unable to create
socket
The connection task for a TCP client device was unable to create a
socket for the connection.
(continued on next page)