System information

Crestron 2-Series Control Systems Reference Guide
Reference Guide – DOC. 6256A 2-Series Control Systems • 119
2-Series Console Commands (continued)
TOUCH
Description: This command selects the touch input driver for the CNX-DVP4/C2N-DVP4DI. Entering the command without
a parameter displays the current setting.
Help Menu(s): Device
Syntax: TOUCH [input]
Parameters: input – set to a numeric variable from 0 to 12, where:
0 – Program Control
1 – Microsoft mouse (default)
2 – Smart (SC3,SC4,SC5)
3 – Smart (SC6,SC7,..)
4 – Microtouch
5 – Dynapro SC3
6 – Dynapro SC4
7 – Elo Graphics
8 – Crestron Tablet
9 – Mouse Systems Mouse
10 – Logitech MouseMan
11 – Wacom Tablet
12 – QTC Touch Controller
Possible Source: RS-232, CTP, Telnet, User Program
Minimum CUZ: 1.017
Processor Group: Display Processors
TYPE
Description: This command displays the contents of a file (only works for files under 20K bytes in size).
Help Menu(s): File
Syntax: TYPE filename
Parameters: filename – name of the file to be displayed
Possible Source: RS-232, CTP, Telnet, User Program
Minimum CUZ: 2.004
Processor Group: All Processors
UPLOAD
Description: This command loads a file into a Cresnet touchpanel device. The user starts an Xmodem transfer with the
desired file for the network device (either display or firmware).
Help Menu(s): System
Syntax: UPLOAD [DISPLAY | FIRMWARE] net_id
Parameters: DISPLAY – indicates that the file is a display list for a touchpanel
FIRMWARE – indicates that the file is a firmware upgrade
net_id – Cresnet ID of the touchpanel device (in hexadecimal)
Possible Source: RS-232, CTP, Telnet
Minimum CUZ: 1.001
Processor Group: All Processors
(continued on next page)